So I bought the tin can mike kit, and am a bit...underwhelmed.
Used hot glue. The disk does not touch the metal because of the glue. Should I have glued from the top?
If it doesn;t matter, even with an amp, it doesn't put out much volume.
Are there different value discs? Does size matter?
Tags:
So.... I have a crap acoustic guitar that I have salvaged parts from, and now it want's to get in the mix a little. It had a saddle with a piexo rod under it. I'm looking to rework that a bit. Does a rod piezo need to be in direct contact with bridge/saddle material, or will it pick up vibes from just the wood? Let me try for a better description... If I leave the rod in it's saddle groove and find the correct size all-thread or bolt, can I just lay the bolt on top of the groove where the saddle would normally go? Or must there be metal/rod contact?
You can imbed it into the bridge with good results, but having direct contact with the strings is the best? Or loudest? You can even encapsulate it like a sandwich? And yes, the piezo should have glue between it to dampen some of the noise? I would also try a preamp with the mic? I've made a few of those & it was pretty loud thru just an amp? Shane has a whole section about it in his book?
Started by James Pobog. Last reply by BrianQ. Sep 25, 2019. 2 Replies 0 Likes
Posted by Vlad on March 31, 2024 at 11:48pm 0 Comments 1 Like
Posted by Vlad on March 6, 2024 at 2:32am 5 Comments 2 Likes
Posted by billy jones bluez on February 28, 2024 at 2:09pm 0 Comments 0 Likes
Posted by billy jones bluez on February 17, 2024 at 11:00pm 0 Comments 0 Likes
Posted by Vlad on February 11, 2024 at 1:06am 1 Comment 1 Like
May 11, 2024 from 11am to 8pm – Speakeasy Grill
0 Comments 0 LikesMay 30, 2024 from 6:30pm to 10pm – The Casual Pint of Huntsville
0 Comments 0 Likes© 2024 Created by Ben "C. B. Gitty" Baker. Powered by
Cigar Box Nation is presented by C. B. Gitty Crafter Supply, your one-stop-shop for Cigar Box Guitar parts and accessories!