So I bought a little 'amp" circuit on ebay based off of some comment I saw here on the nation metioning them.  It was only 3 bucks, so I figured what the heck.  anyway, it showed up, but no wiring diagram, and I don't want' to fry it.  It has some marks on it, perhaps someone has some knowledge on it.  the white circle with the slot turns....I think some sort of gain/vol.  then 4 prongs on right side say grd, grd, in and vcc.  then other side, i assume is speaker out, has green plastic bracket with screws that tighten down (I assume you clamp wires in there) and they are labeled grd and out.  My assumption is the "in" is the feed from jack, the vcc is the hot from battery, and then the grd are the respective grounds for them, which I assume all ground are interchangeable.  thanks for your thoughts!


Views: 972


Replies to This Discussion

Yes, you are correct with your connections. I have the 200 gain circuit & it can drive a 2X8 cab pretty well. You can also add pedals & the board seems to hold up. Have fun!!

Hi Harley,

They caught my eye too but mine is still in the post.

I think you have sorted it out by yourself.


My thoughts are

from other circuit boards I have played around with

The green connections on the left will be to the speaker.

For the other 4 pins IN will be the hot input wire

VCC will be the 9v postitive from the battery

The other 2 GND need one for the battery negative and one for the guitar input negative.

If wired like this and it doesn't work then add another wire across the two grounds as I think this gap is to isolate the battery from the circuit using a break in the battery negative lead so you can easily add a switch here or use a stereo jack socket as a switch.

(Jack plug as a switch - you can wire the two GNDs one  to each of the two negative lugs on a stereo jack socket so it acts as an on/off switch. When you plug in a mono jack plug from a guitar lead. - the shaft of the plug connects the two GNDS so the battery becomes part of the circuit and it switches on).


Good luck and let us know what you think of the sound.




vcc is +voltage in. grounds should be the same electrically. Your other assumptions sound correct. email ted crocker to verify. good luck

do u have a link on ebay 44 this amp?

I think this is the one I bought...David's link is good too...they have a few different "models"...not sure on difference.  Thanks to everyone for comments on my wiring, I will hook it up this weekend and see how it sounds..then report back.


If it works, can't beat the price.  I will add that if price isn't an issue, I have the MAH 5 from and it is a great amp...about $40, but I put it in a cigar box and it has multiple tone and distortion adjustments, mp3 imput so you can play along to songs, etc. 

The MAH 5 is a really good amp. I had some old JBL surround speakers and used the 4 inch speakers out of them and put them in a craft box from hobby lobby and it really rocks. Give it a try.

These are only about .5 of a watt, but they do crank for "watt" they are!!

Here's another I tried, has external volume pot & a pin to go from clean to gain, not a bad unit. These are actually quite a bit larger then the one shown in this post. I had thought that a LM386 would only be one size, but apparently not.

Would you say the one you tried (and the link you posted) is louder/better? is it more wattage?  For $7 it's still a bargain. 

Also, for yours or the .5 watt one I posted above, does anyone have thoughts on 4 ohm or 8 ohm speaker?  I hear a lot about that in discussions but never really understood it.  thanks.

I've got that module in an old bakelite speaker cabinet from the 1940's (the speaker cone is from the same era too) and it sounds really great. Far better than you would expect. I've bought a few more and am on the hunt for some more vintage speakers to hook them up to. I'll try and take some pics later and post them :)

Hey Harley, I would say the 7$ one is a little louder, but having the option of a clean or gain amp is nice, or you could add a gain pot for adjustment. I run both at full volume & find for me I like lower ohm speakers for low watt applications as it adds to the DB level. I have 2 8" 4 ohms in parallel in a 20w buskin amp I built that also has the option as being a cab & the little boards drive them pretty good. I also built this little radio amp with the 7$ board into a 4" speaker & it sounds nasty!!


The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building Basics

Site Sponsor

Recommended Links & Resources

Discussion Forum

Ruby Amp

Started by BrianQ.. Last reply by BrianQ. May 18, 2020. 6 Replies

Smokin' amp (literally)

Started by James Conder. Last reply by James Conder Aug 27, 2019. 4 Replies

Simple Headphone/Practice Amp

Started by BrianQ. May 16, 2019. 0 Replies

Problem with second-hand amp.

Started by Arthur Payne Mar 31, 2019. 0 Replies

Artec Amp Help!

Started by Jesse Lively Sep 10, 2017. 0 Replies

LM386 N-4

Started by Denis U. Last reply by Richard Haas Dec 3, 2016. 4 Replies

History Mystery--Orrtronic Tube Amplifier project

Started by Scott aka Farmer Ted Nov 17, 2016. 0 Replies

Dual IM386 Chip amp

Started by Paul Craig. Last reply by Paul Craig Nov 3, 2016. 31 Replies

Amp Speakers

Started by Primitive Acoustics. Last reply by Primitive Acoustics Mar 9, 2016. 3 Replies

Grounding for Cigar Box Amps: Chassis Ground?

Started by Erik Bell. Last reply by Scott aka Farmer Ted Dec 20, 2015. 4 Replies

Neat amp components

Started by Surly. Last reply by Alan Steeg Oct 27, 2015. 1 Reply

can a dab radio be turned into an amp

Started by Coventry Halfpenny guitars. Last reply by Pickedmoor Jon Oct 20, 2015. 3 Replies

SDA-T Questions

Started by alectron. Last reply by Zac Ray Sep 2, 2015. 10 Replies

HI - New guy & And speaker question

Started by Henry S. Last reply by Henry S Mar 25, 2015. 4 Replies

Are Pre-fabbed LM386 Moduals Worth Trying?

Started by Scott W. Last reply by Henry S Mar 24, 2015. 6 Replies

Powered sub to amp ??

Started by wormil. Last reply by wormil Sep 2, 2014. 2 Replies

Amp and speaker INSIDE the guitar?

Started by Greg Potts. Last reply by Ron "Oily" Sprague Jul 1, 2014. 1 Reply

trying to hack an old valve radio, into a guitar amp,

Started by GARAGE HERMIT. Last reply by GARAGE HERMIT Apr 29, 2014. 108 Replies

Best mini amp KITS

Started by MichaelS Country Boy Guitars. Last reply by Henrik Johansson Mar 10, 2014. 34 Replies

amp wiring help

Started by HarleyTodd. Last reply by Bernie Mango Feb 26, 2014. 18 Replies

Blog Posts

Who will be the first to embed GO in CBG? =)

Posted by Vlad on December 6, 2023 at 12:17am 4 Comments

My first CBG from Captain Nemoff.

Posted by Vlad on November 29, 2023 at 3:41am 0 Comments

New Album 2023

Posted by Gary O'slide on November 5, 2023 at 2:41am 0 Comments

Latest Activity

Justin Stanchfield replied to Justin Stanchfield's discussion Best power tool for building?
"Thanks for the advice. I took woodshop way back in school and over the years have used table and…"
1 hour ago
Taffy Evans replied to Justin Stanchfield's discussion Best power tool for building?
"Hi, for me...all of the above.Hahaha. But seriously, when I started I made my table saw. made my…"
2 hours ago
Justin Stanchfield replied to Tim O'Flynn's discussion Cutting down the neck of a CBG
"I was thinking the same thing. My wife gave me that kit for Christmas a few years back and…"
3 hours ago
Dab and Darryl Tuttle are now friends
3 hours ago
Dab left a comment for Darryl Tuttle
"Not bad just trying to learn how to play it now.. my bridge was too tall and I shortened it I got…"
3 hours ago
Dab left a comment for Darryl Tuttle
3 hours ago
Darryl Tuttle left a comment for Dab
"Welcome to CBN? How’s the build going?"
3 hours ago
Justin Stanchfield commented on Doug Thorsvik's video
4 hours ago
Justin Stanchfield commented on Glenn Kaiser's video
4 hours ago
Justin Stanchfield posted a discussion

Best power tool for building?

Apart from a Makita drill, a Dremel and a couple of chainsaws, everything I build is done with hand…See More
4 hours ago
BrianQ. posted a status
"Been posting in visual mode with no problems since the latest maintenance update, is it fixed or am I just lucky?"
9 hours ago
BrianQ. left a comment for Dab
9 hours ago



© 2023   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->