Wooden Guitar Slides from Scotland 🏴 Demo!!!!
"Great Sliding ! But to be honest i dont hear that much a differens, beleave the Glass is a…"
Attach sides to base
Use the hinge to reconnect the foot pedal
Attach the small 5 inch piece of scrap to the front of the pedal, this should stick out about 1 1/2 inches
Place the pedal on top of the base, secure with 2 screws at the heal of the pedal
Slide the dowel into one side of the side piece.
Slide the beater holder on with the courier facing away from you. Small piece that holds the rubber band goes on the end. You will need to counter sink and drill them into place when you get them into the correct position.
Here is the correct position. I would wait to screw on the beater piece until closer to the end when the extent in is connected. See the small hole in the scrap wood attach the connected there.
Now connect both pieces and secure the beater holder. The holes need to be big enough on the connecter that they move freely but small enough to stay on the screw.
To make the beater I drilled a hole in a piece of 2 x 2 and sanded it.. The beater could be anything a spoon, no rules here.
Attach the cup hook, I used an eye hook and cut some out be use that's what I had.
Add the rubber band and your done.
