I want to use this diagram but take out the tone control and the Tele type 3 way switch and use a 3 way mini toggle instead ? .

Views: 1575

Reply to This

Replies to This Discussion

Yes. All a tone controll does is dump the higher frequencies to ground. 

Like this...

 no not the same ? i want 2 volumes and a mini ( on on on ) toggle switch , it's the wiring of the switch i'm having trouble finding out about , but thanks for the reply ...

Here's two links that might help you with wiring a three way toggle switch

http://www.ultimate-guitar.com/forum/showthread.php?t=1019006

http://www.1728.org/guitar.htm

or at least set you in the right direction.

Connect the pickups to their separate volume pots. each on post one. Then run the center post to the three way. Make sure to ground post three of both pots to the back of the pot. And ground one pot to the three way switch. 

If you look at the ways the on/on/on switch connects the lugs you will see if you wire each set of two lugs across horizontally and you wire the inputs to the top and bottom two and the output to the middle two. It then works like a 3 way.
Attachments:

 Thanks David  yes that worked ok ? did wire the switch the wrong way round but swopped wires over and it's all ok , thanks again ...

 I've had a problem with this , worked perfect with a Disc Piezo which I'm not a fan of so I changed it to a Rod Piezo ( taken from another build ) bridge , now the bridge pickup doesn't work ? the neck pup is fine switch to middle pos neck pup works not very much vol from bridge pup , switch to bridge pos no volume from bridge pup only a loud hum ?? anyone any thoughts on why this is ???? ...

 Update .

  Just disconnected neck mag pickup and the bridge pup works fine and in middle switch pos ? ....

Rod piezos are weaker than discs (and the flexible cable types are even weaker).

The rod needs a higher volume than the magnetic pickup to be audible. If you add diodes to the wires going between the middle lugs of each volume pot and the 3way it will isolate the action of each volume pot so you will be able to blend the two signals so both can be heard. I use 1N5819 diodes for this. You wire the diode with the shaded end pointing towards the 3 way. If you don't have any diodes message me your address and I'll post you some so you can finish the build.

Regards,
David

Ha.  I didn't read all the way down the page before posting my reply.

The comment on the rod needing higher volume is depending on the mag and the rod.  I have used a shorty rod piezo in a MojoboneWorks bridge with bone saddle  with a 3-string flatpup and the rod is hotter.  Same with a 6-string rod piezo in a biscuit bridge and a bone saddle and a 5-string ThinBucker.  The rods are both louder than the mags, but these mags have only 2K-4Kish ohm resistance since they are flat pickups.  And yes, electric guitar or electric resonator strings on both.

This is a big problem with dual volume controls on a piezo and mag setup.  You have two options, only one of which I have done, but the other I trust.

First option is to get a couple diodes and put them inline with the output of each pot.  This prevents signal from going through the pot to ground and not to the jack.  Check this thread and about the 6th reply down to see a link and wiring diagram example.

http://www.cigarboxnation.com/forum/topics/piezo-or-mag-pickups-whi...

http://www.strat-talk.com/forum/stratocaster-discussion-forum/13405...

I have done this and it works very well.  Diodes are cheap too.

The other option comes by the way of The Phrygian Kid and he suggests just connecting the 3rd tab of the pot to ground.  This makes it simple variable resistor.  I did not know this before putting diodes on my guitars and so I have not tried it.  He's more than a trustworthy source of info though.

The last thing to check is to ensure you have a single point of grounding connections.  Only one.  Like, one.  Multiple points of ground can cause huge headaches.  Ground everything to one single point and then to the jack.

I have found the rod piezo/mag dual volume combo to be among the most frustrating to wire up.  Keep at it.

Attachments:

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building Basics

Site Sponsor

Recommended Links & Resources


Forum

Duel output jacks

Started by Justin Stanchfield in Building Secrets, Tips, Advice, Discussion. Last reply by Uncle Toad yesterday. 5 Replies

How to Get Your Own Music on Spotify

Started by Cigar Box Nation in Feature Articles. Last reply by Southern Ray on Thursday. 2 Replies

CB Bass Guitar

Started by Mi Rankin in Building Secrets, Tips, Advice, Discussion. Last reply by Justin Stanchfield Jan 27. 5 Replies

HELP !! IN VERMONT.

Started by Ranblin' Dan Stevens in Other stuff - off topic, fun stuff, whatever. Last reply by Patrick Kelly Jan 21. 7 Replies

Fat Back Neck

Started by Jim Booth in Building Secrets, Tips, Advice, Discussion. Last reply by Jim Booth Dec 15, 2023. 7 Replies

Brick House CBG

Started by Ian Boyd in Building Secrets, Tips, Advice, Discussion. Last reply by Taffy Evans Dec 13, 2023. 3 Replies

Latest Activity

Southern Ray posted a video
3 hours ago
A.D.EKER commented on A.D.EKER's video
5 hours ago
A.D.EKER commented on A.D.EKER's video
Thumbnail

Rapture (instrumental) BCB 2024

"Thanks DOUG and KALE  glad you approve ,in a cranky Blink ! preaceate !"
5 hours ago
Andy joined Cigar Box Nation's group
Thumbnail

How to Play a Cigar Box Guitar

Playing tips and secrets. Tunings. Primal music theory.See More
7 hours ago
Andy joined John Sims's group
Thumbnail

Secrets of the CBG Underground

Tips, Tricks of the Trade and Secrets that (almost) no one is supposed to know about...Tell us your…See More
7 hours ago
Andy joined Wade's group
Thumbnail

Low Budget Land

Cigar box guitar builders are a creative and resourceful bunch. Share ideas for CBG materials and…See More
7 hours ago
Andy joined 3 String Blues's group
Thumbnail

Homemade Guitars

This is the group for homemade instruments that venture out from the standard cigar box guitar.Post…See More
7 hours ago
Andy joined Cigar Box Nation's group
Thumbnail

DUMPSTER DIVER'S MUSIC UNION

Scavengers unite! We want to know what unusual trash you've used to build instruments. Post your…See More
7 hours ago
Andy joined Mark Bliss's group
Thumbnail

Intermediate building tips and tricks forum

This forum is for sharing general building information that falls between "CBG building 101" and…See More
7 hours ago
Andy joined Mad Mike's CBG's's group
Thumbnail

The Beginners Club

A club for beginners who are building for the first time and need some support from each other as…See More
7 hours ago
Andy joined Habanera Hal's group
Thumbnail

Sell Those Puppies!

A group to discuss selling the instruments and accessories we build.  Where to sell, how to…See More
7 hours ago
Andy joined Charlie's group
Thumbnail

New York Cigar Box Guitars

The Cigar Box Guitar group for builders and musicians in the New York area.
7 hours ago

Events

Music

© 2024   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->