don't you just love it when you are working on a build and mess something up...and then throw a fit and aftermath of the tantrum is worse than the initial mistake...maybe i shouldn't listen to metal when i am building
You need to be a member of Cigar Box Nation to add comments!
Anyone know what the required number of extra vibration holes needed while putting in tuners. At least thats what I called them when someone asked what the extra holes were for...
Anyone know what the required number of extra vibration holes needed while putting in tuners. At least thats what I called them when someone asked what the extra holes were for...
I am holding my breath at the moment......I just drilled the holes for tuners only to find should of used smaller size......6 7 8 9 10...they bolt up ok, just hope they dont move once strings put pressure on them.........&^&^$^#%$#@%%$&$##^()&^&%&$#$*^....fingers crossed, keep you posted
Somewhere in the woods behind my house is at least 1/2 a set of handtools that have sailed into the woods ,one tool at a time over the last 20 years.This was perfectly planned so the people that come after us will have something to dig up after I'm gone.
They will marvel at the pretty chrome pieces some idiot "lost" and try to figure out what they were used for.I'm sure they'll try to understand how those large tools were used on the modern computers that will run their lives ,,,,
Took a hammer to one one time. Splintered all over the workshop. Good thing was the neck was still intact. I used it on another build that turned out great
Replies
Roy E. Queen said:
They will marvel at the pretty chrome pieces some idiot "lost" and try to figure out what they were used for.I'm sure they'll try to understand how those large tools were used on the modern computers that will run their lives ,,,,