Replies to This Discussion

Permalink Reply by Jim Mitchell on July 28, 2010 at 9:51am

Hey if you check out Frank Fords website he has a good tutorial on making a fret spacing rule. (lots of guitar making info)

www.frets.com

• ▶ Reply

Permalink Reply by Wes "I'm Baaaaack" Yates on July 28, 2010 at 12:24pm

I will post a more hi res version on my page. Use the higher res version as a guide to cut the nut or saddle/bridge string spacing. The horizontal lines are for alignment, NOT fret placement or fret markers. -WY

• ▶ Reply

Permalink Reply by Scott L on July 28, 2010 at 3:34pm

The spacing of the strings is really a matter of preference. You might want to make them like a regular acoustic spacing though. It won't have impact on the sound as much as your comfort in playing. Bottom line, not too close together, not too far apart. I guess if they are too far apart a chord wouldn't sound right and too close together a chord might buzz or sound jumbled. I have plenty of regular guitars laying around the house, I will see what the average is on an acoustic and let you know. I'm guessing that you could just about lay an average #2 pencil in between the strings, maybe a little closer than that.

• ▶ Reply

Permalink Reply by John Drake on July 28, 2010 at 7:57pm

I found this Spacing Chart very useful. Spacing is compensated for the thickness of strings (rather than all being equally spaced), so you get equal spacing between strings and not from centre to centre of strings. To use just use a rule or paper marked with the width of your fretboard or neck and place across the 4 strings that you are going to use (probably the 5th, 4th, 3rd & 2nd), allow about 3-4 mm neck width greater than the strings on each side. Original came from somewhere on this site. Regards John D

• ▶ Reply

Permalink Reply by Wes "I'm Baaaaack" Yates on July 29, 2010 at 2:12am

Got this in a high res format??? Looks like a DWG or can it be made into an EPS?

-Wes

John Drake said:

I found this Spacing Chart very useful. Spacing is compensated for the thickness of strings (rather than all being equally spaced), so you get equal spacing between strings and not from centre to centre of strings. To use just use a rule or paper marked with the width of your fretboard or neck and place across the 4 strings that you are going to use (probably the 5th, 4th, 3rd & 2nd), allow about 3-4 mm neck width greater than the strings on each side. Original came from somewhere on this site. Regards John D

• ▶ Reply

Permalink Reply by John Drake on July 29, 2010 at 1:42pm

Best I have is this pdf file.


Wes Yates said:

Got this in a high res format??? Looks like a DWG or can it be made into an EPS?

-Wes

Attachments:

• NUT LAYOUT.pdf, 125 KB

• ▶ Reply

Permalink Reply by Wes "I'm Baaaaack" Yates on July 29, 2010 at 5:31pm

Super! Thanks.

-Wes

John Drake said:

Best I have is this pdf file.


Wes Yates said:

Got this in a high res format??? Looks like a DWG or can it be made into an EPS?

-Wes

• ▶ Reply