Replies to This Discussion

Permalink Reply by Blues Frog on August 20, 2015 at 5:37pm

can you show the way you have it wired?

• ▶ Reply

Permalink Reply by darryl kernaghan on August 20, 2015 at 10:43pm

Without a diagram or pics,that sounds like your vol output is going to the tone pot,then back through vol pot,or maybe vol to tone to jack,on my builds,the only wire that goes to jack is middle lug from vol pot,plus ground of course

• ▶ Reply

Permalink Reply by Richey Kay on August 21, 2015 at 3:03am

A photo of the way you have it wired would really help.

This is the one I use:

• ▶ Reply

Permalink Reply by The Capo Kid on August 21, 2015 at 4:53am

This is the way I do most of my wiring and it's build No 19 and never had this problem before ?? all ways a first time ?

• ▶ Reply

Permalink Reply by darryl kernaghan on August 21, 2015 at 6:44am

that looks ok to me Kid,check joints,then next is probably a bad pot,does the volume change when you have full tone,and move volume pot?I'm not the full bottle on electrics,but if i was to do an elimination exercise,i'd probably start with the cap,then the vol pot

• ▶ Reply

Permalink Reply by David L. on August 22, 2015 at 6:24pm

It may just be the picture angle but the capacitor looks like the leg from the middle lug of the tone pot is shorting on the back of the pot (so the rest of the cap is bypassed) resulting in the tone pot acting like a volume pot. Try lifting the cap up so the leg from the middle lug is clear of the pot back

• ▶ Reply

Permalink Reply by Tom T on August 22, 2015 at 6:42pm

Excellent observation. I blew up the photo and I think you nailed it. The center lug of the pot looks like it's shorting to the back of the pot via the leg of the cap. Easy to check. Just pull the cap up so it is clear an re-check.

• ▶ Reply

Permalink Reply by The Capo Kid on August 23, 2015 at 12:01pm

 No it's ok I checked it's not touching ? I re -did all the solder joints and it's ok now ?

• ▶ Reply

Permalink Reply by darryl kernaghan on August 22, 2015 at 9:05pm

Good get David

• ▶ Reply