#1 resource for Cigar Box Guitars, Free Plans, How-To, Parts & More!

Neck Drop Angle?

I tried a search of this forum but didn't come up with hits that addressed what I'm talking about.

I'm new to CGB building and have spend a number of evening bouncing around the internet looking at building instructions and videos.

I hit a video a few days ago that talks about cutting a 3 degree taper on the top side of the portion of the neck that is inside the box. This will cause the neck to angle downward (from box to head).

According to the video, this is done to address bending of the neck under string pressure and help keep the action height constant across the length of the fret board.

Is anyone familiar with this technique? Is 3 degrees the default standard?

Thanks

Tom T

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by darryl kernaghan on October 19, 2014 at 9:27pm

i always rake them now,Tom,but i HAVE overdone it in the past

▶ Reply

Permalink Reply by Tom T on October 20, 2014 at 6:43am

Thanks for the photo Darryl. Nice looking piece. I can see where too much angle would be a problem, but it seems to make sense.

Tom T

▶ Reply

Permalink Reply by Uncle John on October 20, 2014 at 3:37am

Interesting. I've believed in angling down the neck and I have usually done it.. This last year or two, I have played guitars by two well regarded CBG builders who do not angle or rake the neck. They played and sounded quite well.

My last build was a just for fun quicky on a Saturday. Built in a few hours - a neck through with an added quarter inch fret board --no neck rake. It played and sounded excellent.

▶ Reply

Permalink Reply by Tom T on October 20, 2014 at 6:45am

Hi John.

Thanks for adding to my CGB growth. My first build (3-string, fret-less) had no neck angle and, as you say, it plays fine. Still, I want to learn as much building technique as possible so I can build a better piece next time.

Tom T

▶ Reply

Permalink Reply by Bad Finger (Eric) on October 20, 2014 at 4:40am

I don't know what the angle is, but I like it. I also make the bridge last and use a metal rule edge on the fretboard to get a rough height requirement. I also don't like the neck back angle to be so extreme that the headstock is a resting point lower than the back of the box if you lay it down. With thin boxes, this isn't always possible, but I try.

Generally, I just draw a line on the part of the neck going inside the box and plane off the top surface to that line.

▶ Reply

Permalink Reply by Tom T on October 20, 2014 at 6:48am

Thanks for the photo, Eric. It always helps to see what you are talking about. I understand concern with the head stock being the main contact point for the guitar.

I will keep making drawings and try to learn as much as possible from this site.

Tom T

▶ Reply

Permalink Reply by RTZGUITARS on October 20, 2014 at 7:19pm

The neck angle is important to playability, and depends on what bridge height your going for. You don't have to have it but if you have a bolt on neck you can change the angle later if needed.

▶ Reply

Permalink Reply by Tom T on October 20, 2014 at 11:25pm

The more I read, the more a bolt-on neck makes sense.

▶ Reply

Permalink Reply by RTZGUITARS on October 21, 2014 at 4:49am

Same difference screwed and glued or just screwed but if the neck starts to get a little relief as time goes by you unscrew it and change the angle or if you install a new pickup and need more height. I do both then I tried this which work great.

I don't build for profit so it gets old building the same way.