Forums

Cigar Box Amp Power

Posted by Paul W. McGuire on February 21, 2018 at 4:32pm in Building Secrets, Tips, Advice, Discussion

i bought a 9volt battery Cigar Box amp from CB Gitty. Is there a way I can solder in something so it can be powered by a guitar pedal power adapter?

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

Email me when people reply –

Replies

Jerry Jordan February 22, 2018 at 7:12am

The simple way to do this is just to cut the end off the wall wart cable and solder it to a 9V battery clip.,,.make sure you pay attention to the polarity of the 9V.,.,then you can just connect the 2 battery clips together.,.,the one from the amp and the one from the wall wart.,.,
Paul W. McGuire February 21, 2018 at 6:14pm

I’m going to take parts off and old pedal

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use Cigar Box Nation.

Please check your browser settings or contact your system administrator.