sorry that I'm not clued up on these.
even at 62 I've still a lot to learn,never to old eh
so what do these do??
I've seen them advertise on Gitty's inc chic/john page.
You need to be a member of Cigar Box Nation to add comments!
This reply was deleted.
Replies
They are very easy to fry with your solder iron, and will appear (and smell) unaffected, allowing you to scratch your head and puzzle over circuit diagrams for hours wondering what you did wrong.
Great fun :)
http://www.harmonycentral.com/forum/forum/guitar/acapella-41/1106532-
sorry 3.3k resistor in this diag
Also google Cocked wah wiring, which uses a small cap and a 100k resistor on the vol pot for volume bleed
gives you a differnt sound to normal which is marmite...
Typical strat has a 0.1 for lots of twang, humbuckers use 0.022( gibson les paul), single coils work well with 0.047 or 0.033
or woman tone is a 0.015 (warmth) (humbuckers mainly)
I got loads of russian PIO oil and paper one if you need any cheap..Used to sell them on the bay and make bumble bee copies.
0.047 PIO is a good bet if anyone needs some let me know as I have stock
They sound like the ones in guitars from the 50's as its the same technology...and make the biggest difference for bleeding off the tone for warmth..
Most of mine have 0.047, 0.067 or 0.033 in them..
decent CTS big tone pots also help like lots! and decent strings.. but cheap ones are ok from china too..
As others have said, capacitors on the tone control allow you to 'chop off' the high frequencies. The bigger the number, the more frequencies can be chopped. So, a 0.047 microfarad capacitor will allow you to make the guitar sound darker (duller) than a 0.015 microfarad cap. They act in combination with the tone pot, which controls how much of the pickup signal goes through the capacitor. There's a lot of stuff talked about the best combination of pickups, control pots, capacitors and resistors........and amps.
Wiki has a useful article on guitar wiring:
http://en.wikipedia.org/wiki/Guitar_wiring
A Capacitor acts like a short circuit to a high frequency signal and acts like an open circuit to a low frequency signal. By putting it in series with a variable resister (potentiometer a.k.a. POT) you get a variable tone control that can take a little or a lot out of the high end.
You can also use a capacitor on your volume pot. If you have a store bought electric guitar you may have noticed this already. When you turn the volume down you loose some of the high tones. Putting a capacitor on your volumes pot will keep these high frequencies from dropping out.
capacitors in a guitar context act as a frequency filter for tone control, different values can give you a different tonal range.