Bucker minus screws vs P90.. I seen a guy take the screws out of one side of a humbucker and it sounded more like a single coil.... what do you think this would sound like vs a P90...I love P90 sound but just can't take the noise of singles... I also know they make a P180 so..any thoughts?

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

Email me when people reply –

Replies

  • Keep the screws in and try this;

    http://www.jpbourgeois.org/guitar/microsbis.htm#twist

    It sounds GREAT. The down side of using a humbucker as a single coil is they're not wound to be used that way. They don't sound as good as a single coil pickup. Being variable you can beef up the single coil sound by turning the knob back up a bit. All the way from twangy single to humbucker.

  • Great, thanks

  • Also I forgot to mention the Lindy Fralin P90 is actually better sounding than the Gibson made pickup & not noisy @ all.   don't over think yer choice of pickups,you'll get caught up in pro's & con's so much yer judgement will become too indecisive and you'll end up stifling yerself. in short, don't use cheap pickups & install them properly & you'll be fine. all pickups become noisy when yer playing @ higher volume W/ high gain.it's just that way?   

  • What you're looking for is  called a P100, it's a P90 sized pickup W/ another coil stacked underneath it(stacked humbucker) if U take the screws out of a humbucker,yer basically taking the sensitivity to vibration out of it,U can do do it much easier by lowering the height of the pickup to get the same effect. IMO it's a waste of a humbucker? when U can just install a single coil? I've never had noise problems from P90's, I use Gibson & Seymour Duncan brands. if U use cheaper non american made pickups then yer gonna have noise problems. especially if they're not wax potted,wich is an easy fix. another thought: if U take the tendency for howl due to pickup vibration by either wax potting or a simple piece of foam sandwiched between pickup & body this will quiet them down.the easiest way to amplify yer guitar is to not think too much about it,just do it.

    • no, you're only removing this 'sensitivity to vibration' from one of the two coils, the other has fixed pole pieces.  So it's hardly the same thing as lowering two poles.

      The noise we are talking about cancelling out with this is a different thing entirely from microphonics which can be beaten with potting or with a more expensive coil.  Even the most boutique single coil will be susceptible to hum.

  • I agree. The best way to get a noise cancelling soapbar will be to wire in series with a second one which is identical but rwrp (bust the magnet off and flip it over, reverse the 2 wires) and with the second removed from the strings ( so it only 'picks up' the hum and noise)

    This is what skee6 means by 'dummy coil' and what you're aiming for by removing those screws. Usually a dummy coil is stacked beneath the real one, that's how most 'noiseless' singles work. I said in series, it'll actually work in parallel too, but probably with significantly less grunt. You could add a dpdt switch and have both if you liked..
  • I think it might work, or at least get you in the ballpark. The coil that you take the screws out of would become like a dummy coil. Gibson Blueshawks are an example of guitars which have a dummy coil. The coil is wound reverse to the main coil, so it helps with hum.

    The main coil would act sort of like a P-90 except it's not as wide and flat. The presence of the dummy coil should add to the resistance possibly making the resistance similar to a P-90. On the Blueshawk, the dummy coil is several inches away. On your humbucker experiment, it will be right next to the main coil. That should make a different sound from the Blueshawk, but I'm not sure what to expect there.

    As with all things associated with pickups, the best thing is to build one and see what it sounds like. You can get sort of an idea by thinking about it, but there's no substitute for actual hands on experimentation.

    If you do build it, post a video so we can see and hear it!

  • Bump

This reply was deleted.