Forums

Replies

  • Jerry Jordan August 11, 2018 at 4:20pm

    You may be able to bridge the output of a 15wx2 amp to one speaker for a 30 watt output to a single speaker. I believe it depends on the circuit and output class of the amp.

  • Jerry Jordan August 11, 2018 at 6:07am

    15wx2 is a power amp circuit, for home or car stereo, you will still need a preamp circuit to drive it. Those are only a few bucks on eBay as well.,,. Happy building!!!

  • Cause the Blue rat August 11, 2018 at 4:05am

    If your talking a two channel power amp then there is no practical reason use half an amp. You would end up with one amp running a 'load' and the other no 'load' 

    Now if your talking a two channel guitar amp. You can set each channel's EQ differently. Say one channel with scooped mids for a more acoustic sound. The other with heavy mids for a fatter rock tone. 

    • Joe Williams > Cause the Blue rat August 11, 2018 at 1:39pm

      Perhaps, but there is to be only one speaker and a mono input.

  • Jerry Jordan August 10, 2018 at 9:05pm

    “2x15” implies a 2 channel power amp. Designed as a stereo power amp. You could run mono in and one side out, but dual mono in and two speakers would use both channels of the amp. But you’re talking about  a power amp that would work best with a preamp as well.

  • Jerry Jordan August 10, 2018 at 2:57pm

    Normally a two channel amp is a two channel pre-amp fed to a mono output amp, and from there to the speaker. What type of "two channel" amp are you referring to? 

    • Joe Williams > Jerry Jordan August 10, 2018 at 3:47pm

      I imagine you've seen them on ebay. 15wx2 pre-built circuits. Not an amp, just a circuit, to be built into an amp.

This reply was deleted.