If you've never ventured into electronics, but always wanted to make your own guitar pedal, then this video is for you.  The guys at DIYguitarpedals created this ultra-easy tutorial using the least amount of parts possible.  

Parts needed:

  • MPSA13 Transistor
  • 10K Resistor
  • 100nf Film Capacitor (code will be 104)
  • 2.2uf Electrolytic Capacitor
  • 1n4148 or 1n914 Diode

That's it.  Get a soldering iron and you'll be crankin' leads to Blue Cheer songs in no time.

Views: 8275

Reply to This

Replies to This Discussion

Aussie boy..lol

been following this guy for a while now. he also sells premade circuit boards for various effect pedals 

http://www.diyguitarpedals.com.au/shop/

I've built a few of these...easy squeezy lemon peazy...and they sound great.

Same parts as listed above, Scott?

Yes, same parts. Made my first with a kit from the diystompbox gentleman in Australia. Think it was about $7 for the pcb board and capacitors/resistors/diode.

After that, I just wired up a few clones.

The stomp switch and potentiometers, I already had in stock/shop.

I tested them with a Kalamazoo model 1 tube amp clone that I built last year.

When engaged and with volume/drive pot set low, there is a notable volume increase with a bit of distortion/fuzz. crank it to 12 o'clock and it gets busy...dial it up to max and it is wicked.

The box shown above is one of two that I made from leftover blocks of sapele mahogany, with a birds eye maple top.

nice pedal box scott...

Thanks Timothy...I have two of these.

Scott, im newbie on electronics, can you put a diagram for the plug and volume pot? it will be great!

http://www.diyguitarpedals.com.au/shop/boms/7_Min_Fuzz.pdf

This link is the diagrams and details of the 7 minute fuzz pedal. Most of the info is relative to the pre-etched circuit board and parts available through diystompboxes.com.au

But if you're building from scratch with your own available parts, this is document is very helpful.

For bass guitar players, there is also a section here that shows how to modify this circuit to make a bass guitar fuzz, but switching the capacitors for higher values.

Does this work with piezo-electric inputs or just the standard electric guitar pickups?

Piezo or electric will work through the circuit.

It'll probably feedback like a banshee. Distortion is best on mag pickups

It sounds more like a distortion effect rather than a "fuzz" tone. Looks easy though.

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building BasicsCigar Box Guitar Parts Store

Site Sponsor

Recommended Links & Resources


Forum

Discussion: Toothpick Frets?

Started by Habanera Hal in Feature Articles. Last reply by Mark Miller Nov 17. 27 Replies

Your take on this bizarre guitar

Started by Infirmity Citrus President in Building Secrets, Tips, Advice, Discussion. Last reply by Vladimir Mazic Nov 16. 11 Replies

Build this Wooden Kick Drum Pedal

Started by Rose Ericson in Feature Articles. Last reply by Murray Wall Nov 12. 34 Replies

Latest Activity

Korrigan commented on Korrigan's video
52 minutes ago
Doug Thorsvik commented on Doug Thorsvik's video
Thumbnail

Silver Bells: 2-String Surf Chugger Cigar Box Guitar

"Glad to hear it Uncle John! I hope the mood continues because at least another five Christmas songs…"
1 hour ago
Rich commented on Uncle John's photo
Thumbnail

CBGers are a handy bunch.

"I try to keep at least one foot on the ladder."
2 hours ago
Rich liked Uncle John's photo
2 hours ago
Engblom replied to Engblom's discussion Anyone with experience in 1-3-1 tuning?
2 hours ago
Uncle John commented on Lappy's video
Thumbnail

“Leave It There” homemade resonator guitar

"I'm back again, Lappy.  I really like the song and the way you presented it with your…"
3 hours ago
Uncle John commented on BRUCE HALBOHM's photo
Thumbnail

colander & chevy hubcap #1

"I like that quite a lot.  And such a versatile tuning that I use a lot."
5 hours ago
Uncle John commented on Chuck otto's photo
Thumbnail

116

":D"
5 hours ago
Uncle John commented on Doug Thorsvik's video
Thumbnail

Silver Bells: 2-String Surf Chugger Cigar Box Guitar

"Nice.  I am in a Christmas song mood."
5 hours ago
Uncle John commented on Lappy's video
Thumbnail

“Leave It There” homemade resonator guitar

"Lovely song and instrument,.  You are a true luthier and great old timey performer.  "
5 hours ago
Uncle John posted a photo
5 hours ago
Chuck otto posted a photo
6 hours ago

Music

© 2022   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->