Comment

Comment by Dave Lynas on January 5, 2018 at 3:26pm

Thanks Maddog. Time enough to choose Uncle. More are on the way. This batch shrunk more than the last batch by quite a bit. Some became Runts (under 1 1/2 inches). I chose a runt for my collection that is working great. This firing was very hot and long. From 6am till 1am the next morning. It’s difficult to hit the size you want due to the variables in firing. I just must make a lot to get what is needed. I’ll have lots of slides eventually.

Comment by Maddog on January 4, 2018 at 8:03am

Cool factor..........off the charts!!!

Comment by Uncle John on January 4, 2018 at 5:45am

Choosing could be difficult. 

Comment by Dave Lynas on January 3, 2018 at 2:04pm

No Rev. Raku is low temp. Firing. I’m firing to cone 10. About 2300 degrees f. Porcelain needs high heat and becomes very hard. Racu is very soft and strings would rub a groove in the glaze quickly.

Comment by Gary W aka Rev. Bluejeans on January 3, 2018 at 1:15pm

Is Shino similar to "Raku"?   Coolness, Dave!

Comment by Dave Lynas on January 3, 2018 at 11:09am

Thanks Pick, Korrigan and Bones. I think i’ll Have lots of fun with these babies. 

Comment by Dave Lynas on January 3, 2018 at 11:07am

Thanks Bob. Your new bottlenecks look great. I’ll have to have one when you are ready.

Comment by Jeff 'Bones' Reilly on January 3, 2018 at 9:26am

killer Dave . 

Comment by Korrigan on January 3, 2018 at 6:42am

Those are great Dave!

Comment by the anonymous pick on January 3, 2018 at 6:05am

:-O