Replies to This Discussion

Permalink Reply by Richard Dean on November 15, 2017 at 11:30am

black wire is usually hot, you twist the other 2 together and both are the ground. coils only have 2 wires, the third is a shield wire inside the cable, used for grounding purposes. It's a common cable to use when wiring coils.

Find a way to earth ground your strings, wiring a wire from them to the ground connection,will help eliminate unwanted noise.

wiring is a little different if using a vol or tone pot

• ▶ Reply

Permalink Reply by Rupe Power on November 16, 2017 at 11:27am

Thanks for the info

• ▶ Reply

Permalink Reply by Paul Craig on November 15, 2017 at 2:43pm

The bare wire is the cover ground which will also have a small link to the pickup ground wire(white or red) that should be visable. Both of those wires will go to the ground of the jack/pot while the remaining wire will be the signal wire.

• ▶ Reply

Permalink Reply by Rupe Power on November 15, 2017 at 3:27pm

Thanks for the advice.
I've read in other. Discussions that they stuck the ground under a metal bridge.
Any advantage to that?
Thanks

• ▶ Reply

Permalink Reply by Richard Dean on November 15, 2017 at 4:34pm

wherever you can to ground strings, tailpiece if metal

• ▶ Reply

Permalink Reply by Timothy Hunter on November 15, 2017 at 10:11pm

grounding the bridge will reduce hum. 

• ▶ Reply

Permalink Reply by JL on November 16, 2017 at 2:16am

From the very page you pointed at...

This set includes the pickup, which has a 13" 3-conductor lead (red is positive, white negative, uninsulated/silver is the case ground),...

• ▶ Reply

Permalink Reply by Richard Dean on November 16, 2017 at 5:58am

What JL said, I should have looked at the link for wire colors, there are a variety of wire colors out there due to different manufacturers, and especially the China made ones don't seem to always follow any typical guide, I've had them all the same color, odd colors, and humbuckers are worse, especially if you mix coil brands, but not to confuse you, Follow what JL and Paul said.

Happy building!

• ▶ Reply

Permalink Reply by Rupe Power on November 16, 2017 at 11:29am

Thanks

• ▶ Reply

Permalink Reply by Rupe Power on November 16, 2017 at 11:29am

Thanks

• ▶ Reply

Permalink Reply by Rupe Power on November 16, 2017 at 11:30am

Thanks

• ▶ Reply

Permalink Reply by Rupe Power on November 16, 2017 at 11:30am

Thanks

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page