Replies to This Discussion

Permalink Reply by darryl kernaghan on May 11, 2017 at 1:47pm

there are other things that come in to play also, as scale length variation will result in string tension variations, but your general string sets will work ok around the 24-25 1/2 inch scale length, usually giving you the ability to step up or down at least 1 step, often 2, and sometimes even more, the longer the scale length the more tension is required to tune to a particular note, eg. if you tuned a guitar of 24" scale to a G , using the recommended G string, you could easily step that up to A or B, maybe even a C. but on a 25 1/2" scale with the same string, you would be lucky to reach B without the risk of breaking, also stepping up more than 1 step can make it a bit harsh on the fingers, but works well with a slide, not trying to confuse you here, just hoping to save you snapping string

• ▶ Reply

Permalink Reply by Snuffy Smith on May 11, 2017 at 1:55pm

Good info, but all too confusing for a beginner. He should just grab a new set of strings, and start with the 6/5/4 from the set. Tighten the strings till they're a little tighter than "floppy" and wait for the note to appear on the tuner. Tune the 6th to Low G (the first G to appear after floppy), and so on...for Open G tuning. Best way for a beginner.

• ▶ Reply

Permalink Reply by Snuffy Smith on May 11, 2017 at 1:34pm

My best advice to you is to start off with Open G tuning on your CBG. Once you get a firm grasp on that, then move onto experimenting with other "open" tunings.

Here is a list of some common CBG 3-string tunings:

Open G - GDg

Open A - AEa

Open B - BEb

Open C - CGc

Open D - DAd

Open E - EBe

Open F - FCf

Some other possibilities:

DGC

EeB

ACE

FCB

FCE

A#D#a#

F#C#f#

• ▶ Reply

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page