Replies to This Discussion

Permalink Reply by David McQueen on March 18, 2017 at 11:47am

Dee Ann, cut your headstock to depth. Then make yourself a sanding board. Glue sandpaper on a small piece of plywood or chipboard. Smooth the cut on the sanding board and apply the veneer. Even a thin veneer is strengthening.

• ▶ Reply

Permalink Reply by Ron "Oily" Sprague on March 18, 2017 at 10:11am

Next time you do a scarf, try flipping it over so the cutoff piece is above, rather than beneath, the scarf. When you install a fretboard, you can overlay it across the joint, further strengthening it. Or scarf not at all, and do a cut-down flat Fender style headstock.

Another thing to do would be cutting your scarf a lot further along the neck, so that you end up with a longer headstock. Remember, you can almost always start over.

• ▶ Reply

Permalink Reply by Dee Ann on March 18, 2017 at 11:09am

Thanks Ron.  I actually started with 6" of extra headstock.  A couple of scarf joints later....I was down to 2 7/8" for the head.  Great learning curve! :) I'm skeptical of the scarf joint holding up to string pressure when the piece is on top.  I'm using Elmer's Wood Glue...sandable and stainable. It's not the Titebond I was going to get.  I hope this stuff holds. Thanks for your reply.

• ▶ Reply

Permalink Reply by David McQueen on March 18, 2017 at 11:50am

If you have clamps, and you should have clamps, use carpenter's glue. Well smoothed and clamped, the wood will break before the joint.

If you have garage sals in your area, that is where you look for cheap small clamps. I use about 10 clamps when I glue up a headstock.

• ▶ Reply

Permalink Reply by Ron "Oily" Sprague on March 19, 2017 at 8:14am

The joint will hold, especially if you overlay a fingerboard. A large number of commercial gits are done exactly this way.

• ▶ Reply

Permalink Reply by Wade on March 18, 2017 at 12:06pm

More than one way to skin a cat - another option would be to  cut a slot through the center of your headstockand mount your tuners on the side. The advantage is you do not have to remove any thickness to your headstock!

• ▶ Reply

Permalink Reply by Dee Ann on March 18, 2017 at 4:53pm

Very nice!! Love that tin and the slotted headstock.  Yes, I see one in my future. Thanks for sharing.

• ▶ Reply

Permalink Reply by Uncle Fred on March 19, 2017 at 6:21am

Dee,

I have access to an electric planer and plane a long piece of 3/4"x1.5" head material to 5/8" thick.  This could be done with a table saw and fence or a band saw and fence.  A 6' piece will produce a lot of head pieces.

I get neck material length long enough for two necks and cut the neck/head angle in the middle.  This gives me two necks with one head angle cut.  Then I cut two heads from the planed piece in a similar fashion.  I align the head and neck joint for gluing so the overlapping material is the same 5/8" thick as the head.  I end up with two neck/heads for the cutting of one and very little hand work.

If I'm careful laying out the tuners, the top joint between the neck and head can be mostly hidden by the tuner[s].

Safe working.

Fred

• ▶ Reply

Permalink Reply by Dee Ann on March 19, 2017 at 6:26am

Thankk you, Fred.

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page