Replies to This Discussion

Permalink Reply by David McQueen on June 26, 2016 at 8:24am

There you go. Maple headstock with cherry head veneer extended by a piece of maple. The top tuner is screwed on both. The maple extension is glued cross grain so that you do not have end grain to end grain. Getting it clamped properly was not fun.


https://api.ning.com/files/UJ8aoEZo49YBE2U-YU7AjoLuZNsOwddFZOOvRrox...

• ▶ Reply

Permalink Reply by Nicholas Lee Van Divier on June 26, 2016 at 8:41am

Thank you for your addition, looks really good. I guess i will have to get me some good clamps tor that :)

Will be fun to try out and see if i can make it work.

Do you by any chance know if i could also extend the width of the neck somehow ?

Those 2x1" from the hardware store sure don't leave much room for tuners.

• ▶ Reply

Permalink Reply by David McQueen on June 26, 2016 at 11:39am

Take a look on that pic on how the tuners are set up. The headstock is about 6" long and the tuners are alternating. Also, I think the standard setback from the side is about 1/4". This is what the top tuners are. The tuners closest to the neck are as close to the edge as possible. This gives clearance forthe strings. I have set up a driling template for drilling.

• ▶ Reply

Permalink Reply by JL on June 27, 2016 at 2:47am

You can easily widen the headstock, just glue/clamp some wood to the sides.  I use the cutoff from shortening the neck to length, split it in half and glue factory edge to factory edge. 

• ▶ Reply

Permalink Reply by Nicholas Lee Van Divier on June 27, 2016 at 3:13am

Ok thanks, think i will try a bit of both then. Should be able to create some exiting patterns then :)

• ▶ Reply

Permalink Reply by Nicholas Lee Van Divier on June 26, 2016 at 6:45pm

Ok thanks, think i'll go with that approach then. Seems to be very solid and looks great :)
Haven't even thought about a drilling template, but will try making one so the wholes line up perfectly each time.
Thanks a bunch for your input !

• ▶ Reply