Replies to This Discussion

Permalink Reply by Al LaFaver on July 29, 2015 at 3:01am

+1

• ▶ Reply

Permalink Reply by Mark C on July 30, 2015 at 2:14am

I use formby's tung oil. Usually 3-4 coats. It builds up to a nice finish. Poly always runs so I rarely use it. With tung, less is more. Brush or wipe on small areas then wipe down immediately wth the grain where possible making sure no drips or build up. The wiping down is the hardest as tung sets up quickly. Re-wet your wiping cloth if nec. Dry 24hrs., buff gently with 0000 steel wool. Blow or wipe off dust with tack cloth and repeat until you get the finish you want. You'll think your not applying much of a coat, but repeated thin layers produces a fine finish. That's my 2cents.

• ▶ Reply

Permalink Reply by Mark C on July 30, 2015 at 2:24am

To clarify, I'm mostly talking about the finish on the instrument body, back of neck and headstock. Although tung is ok on fretboards , sometimes I just want the feel of wood, so maybe one coat on fretboard or a natural sealing stain . I've used REM oil (Remington gun oil) on fretboards to good effect. If you use tung on fretboards , just remember to wipe off excess thoroughly. Good luck.

• ▶ Reply

Permalink Reply by TN Twang on July 30, 2015 at 7:37am

Totally agree!

Haven't tried Remington's oil. Thanks for the tip.

Last week I broke down and tried Minwax "Wipe On Poly" on an odd-shaped piece of furniture that needed more protection than just oil. I'm impressed. Rub on a THIN coat, wait, buff w/0000, rub on more, etc. No runs & no brush strokes. Multiple thin coats are better than too much at once. Gonna' wait 2 weeks to cure and then buff paste wax with a 0000 pad to get a final polish.

• ▶ Reply

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page