Replies to This Discussion

Permalink Reply by Jon Leslie/Runaway Veal Music on August 26, 2014 at 3:49am

Thanks Robert. I'll look into the hops for sure!
As far as the glue goes I'm still better off than when I started glueing.

• ▶ Reply

Permalink Reply by Michael Fred Johnson on August 30, 2014 at 3:19am

Will the hops in beer work?

• ▶ Reply

Permalink Reply by robert jones on August 30, 2014 at 4:53am

LOL Yep, I started researching hops after I noticed pain reduction and an improvement in mobility  when drinking IPA's. (All it takes is 1, adding more doesn't improve the efficacy.)

IPA's use the high aliphatic acid hops, such as Cascade, for aroma and flavor which contain the pain inhibiting anti-inflammatory compounds.

• ▶ Reply

Permalink Reply by Jon Leslie/Runaway Veal Music on August 30, 2014 at 5:27am

Hmmm

• ▶ Reply

Permalink Reply by Ron "Oily" Sprague on August 30, 2014 at 7:12am

I know what yer thinkin': "Be more fun to just have a breakfast IPA..."

• ▶ Reply

Permalink Reply by Michael Fred Johnson on August 31, 2014 at 12:47am

"all it takes is 1"...spoilsport !

• ▶ Reply

Permalink Reply by Seth Kent on August 26, 2014 at 5:57am

I usually use a sharp knife, or preferably, a good sharp small chisel to remove dried glue.

• ▶ Reply

Permalink Reply by wormil on August 26, 2014 at 7:19am

Vinegar is supposed to remove wood glue but I haven't tried it. 

• ▶ Reply

Permalink Reply by Wade on August 26, 2014 at 12:40pm

Try some heat and a razor blade to scrape off. 

Wade

• ▶ Reply

Permalink Reply by Skeesix on August 28, 2014 at 5:01am

Try using a scraper or chisel to scrape it off.

• ▶ Reply

Permalink Reply by Wade on August 30, 2014 at 6:38am

I haven't tried this on anything major. But there are some builders who use regular Elmer's for most of their builds

• ▶ Reply

Permalink Reply by Slowpaw Steve T on August 30, 2014 at 7:59pm

scrape off the excess glue with a knife blade, Titebond is harder than wood, sanding will take away too much wood. In future keep those sides clean of glue seeping out of the compressed joint with paper until it's settled down.  :-)

• ▶ Reply

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page