Replies to This Discussion

Permalink Reply by John Sawyer on July 27, 2014 at 3:01pm

Don't forget Scale length!  That will have to be a good sized box for the bridge to be in the right position...

• ▶ Reply

Permalink Reply by Paul Marchese on July 27, 2014 at 3:11pm

Scale length will be no problem!

Can't plane it without taking off the top entirely and changing the entire thickness of the top, to my knowledge.

Attachments:

• image.jpg, 1.4 MB

• ▶ Reply

Permalink Reply by John Sawyer on July 27, 2014 at 4:36pm

Wayfinder be smart.

• ▶ Reply

Permalink Reply by John Sawyer on July 27, 2014 at 3:55pm

They are mostly lkywood. I would bet planing it would result in disintegration. Just put a new lid on it... Luan ply would work if braced, IMHO.

• ▶ Reply

Permalink Reply by John Sawyer on July 27, 2014 at 3:56pm

Damn smartphone. Plywood.

• ▶ Reply

Permalink Reply by Muddy Creek Guitars on July 27, 2014 at 5:05pm

I occasionally have thinned a thick lid. I use a palm router with the depth set VERY carefully. It will remove  a fairly uniform amount from wherever you want. This also helps with "stick through" construction as I don't have to notch so much off the stick, making it too weak. BE CAREFUL! making the lid too thin makes it VERY FRAGILE!!

Good Luck!

• ▶ Reply

Permalink Reply by Paul Marchese on July 28, 2014 at 5:36am

Definitely not plywood, John.  Not sure exactly what it is, but I've cut into it to create the dovetail fit, and it's definitely sold all the way through.  I think I'm probably going to just leave it as is, make sure to put a piezo under the top or under the bridge, and cut F-Holes into it...

• ▶ Reply

Permalink Reply by John Sawyer on July 28, 2014 at 9:09am

Probably a good plan.  Like others have mentioned, it might require bracing to keep it intact..  If you take Wayfinder's advice, and screw it closed, you could alter it later, if desired...

I've built about 20 CBG's and 1 Uke to date.  Of all the boxes I've used, most are some sort of plywood.  The Perdomo box I have isn't ply, but the wood is really soft...

• ▶ Reply

Permalink Reply by RTZGUITARS on July 28, 2014 at 11:05am

I sand the top of some boxes down to 3/16 as long as you don't put to many sound holes you should be fine. The area of a normal cigar box top you probably don't need bracing. You want the top to move so less is more.

• ▶ Reply

Permalink Reply by Ron "Oily" Sprague on August 2, 2014 at 2:33am

Not a crazy idea. Easy to do with a plunge router with the appropriate depth set. You can also leave "braces" in unrouted areas if you want (several people on CBN have done this; use the Search for "routed tops" to find example pics). Rout it down to 3/16" thickness. But do it only after you test it unrouted, per Wayfinder's suggestion; you may find it doesn't need it. You can always go back and thin the top if you want.

• ▶ Reply

Permalink Reply by Michael Fred Johnson on August 2, 2014 at 4:33am

The top on this was about 3/8" thick.I routed it down to about half that thickness leaving two 1/2" wide strips the original thickness running across the box to act as braces

• ▶ Reply