tailpiece

Comment

Comment by MichaelS Country Boy Guitars on March 10, 2010 at 4:39pm

Rob, yes I did use a coping saw to make this one and my second CBG. I have switched to an electric saber saw, I can get just as clean a cut in much less time. The hardest part with the coping saw is clamping the lid to the table or bench so I can use both hands to saw with.

Comment by Rob on March 10, 2010 at 3:16pm

you use a coping saw for f cutouts in box?

Comment by MichaelS Country Boy Guitars on February 8, 2010 at 9:46am

The tailpiece was a raingutter bracket, It was a nice u channel that I cut a piece out of, then bent it in half as shown, drilled a few holes and voila.

Comment by HENRY LOWMAN on February 8, 2010 at 12:18am

What did you use for the tailpiece? It looks good!