CRW_7289

Comment

Comment by Alexander Vollschwitz on September 26, 2011 at 3:14am

With the switch you can toggle between electromagnetic and piezo pickup, or use both at the same time (three way switch). With the two knobs, you can control the volume of each pickup.

Comment by Bluesheart on September 25, 2011 at 10:19pm

Seriously like!

Comment by Michael Prout on September 25, 2011 at 5:27pm

Yeah I thought the parts you ran the strings through looked like it was from some electrical connectors.  Nice DIY bridge.  I like the use of the acorn nuts on the knobs.  What is the switch for?

Comment by Michael Prout on September 25, 2011 at 5:24pm

Yeah I was wondering the type of screws and the part that you ran the strings though.  They kind of look like the kind you use for electrical connections.

Nice makeshift bridge.

 

Comment by Alexander Vollschwitz on September 25, 2011 at 4:51pm

I forgot: four short screws (below the hinge) to fasten the four pieces form the insulating screw joint through which the long screws go.

Comment by Alexander Vollschwitz on September 25, 2011 at 4:26pm

The bottom is from a hinge, then four screws and nuts of course, four washers and (most likely what you're wondering about) eight pieces from an insulating screw joint (single row type).

Comment by Michael Prout on September 25, 2011 at 4:15pm

What hardware did you use for this?