strings ?

Replies to This Discussion

Permalink Reply by surffrogg on January 6, 2010 at 4:46pm

john for a ;ap steal i would suggest the heaviest gauge string u can find

Permalink Reply by Ben on January 6, 2010 at 8:25pm

I would agree with heavy...just make sure your git can take it. I pulled mine apart on the first attempt. Now it's pretty much rebuilt and just tonight tuned it up to DADF#AD. I'm scared to push it to GBDGBD.

Permalink Reply by Ben on January 7, 2010 at 11:15am

Update: I pressed my luck and tuned it up to GBDGBD...worked great! I didn't mention it before but I've got a set of the GHS Acoustic Slide Guitar strings on it. They are gauged: .016, .018, .028w, .036w, .046w, .056w. They're chunky but they are also semi-ground down so you get less noise (not as quiet as flat-wound though).

Permalink Reply by Barry Evan Russ on March 29, 2010 at 11:00pm

In my humble opinion, your choice of string gauge is going to depend on a variety of factors. I collect and play several traditional lap steels, and if you are building one like these, basically planks of thick, solid wood, you can use as heavy a gauge as you like. if you tune to open e or d, I agree with the posters, that bigger is better. it's pretty easy to find D'addario medium or heavy Jazz strings and substitute heavier high strings, and you can sub plain third strings too. For playing in C6 tuning i recommend using a lighter gauge string set made specifically for this type of tuning. I have several tuned in both C6 and open D and E, and tonally I like the heavy strings for the open tunings and the lighter strings for the C6.

Permalink Reply by Barry Evan Russ on November 18, 2010 at 11:09am

That toally depends on what tuning you want to use. C6 tuning has a low string of only .38 typically
Blues tunings like open E or D typically have 15-16 high, to 58 to 70 low string. MUch chunkier strings. Make sure what tunings you want to play in because a nut cut for a 60 string won;t perform too well if you switch to say C6 where the low string will rattle around in the slot. Heavier the better for lap steel in open E or D. You want some resistance to the bar, in order to dig in a little and not sharp the strings too much.

Permalink Reply by Barry Evan Russ on November 18, 2010 at 11:10am

Nice, traditional Dobro tuning. Should work great.

Ben said:

Update: I pressed my luck and tuned it up to GBDGBD...worked great! I didn't mention it before but I've got a set of the GHS Acoustic Slide Guitar strings on it. They are gauged: .016, .018, .028w, .036w, .046w, .056w. They're chunky but they are also semi-ground down so you get less noise (not as quiet as flat-wound though).

Permalink Reply by Ronnie Retherford on April 16, 2012 at 8:57pm

I used C6 tuning strings on mine. Love the 'classic country' sound.

GHS GLSC6 LAP STEEL C6-TUNING $4.00 Elderly Instruments