Replies to This Discussion

Permalink Reply by the anonymous pick on January 5, 2018 at 1:15pm

If you kept along the same design , you could use the spout as the soundhole . i fear cutting the back out would weaken it  drastically. 

• ▶ Reply

Permalink Reply by Kigar on January 6, 2018 at 5:52am

You could make it without cutting the bottle, set it on the neck and clamp it. A hose clamp could even be the bridge. 

• ▶ Reply

Permalink Reply by Paul Craig on January 7, 2018 at 10:58am

That's what I was getting at earlier, just didn't think of using it also for the bridge. You could clamp the strings with the clamp, wrap the strings around the screw part of the clamp as a wrap around bridge.

• ▶ Reply

Permalink Reply by Kigar on January 7, 2018 at 1:36pm

I guess I misunderstood, when I read your post I thought you were suggesting a dowel inside the neck where I was thinking the neck stayed outside. The idea to use the clamp and wrap around idea for string retention and bridge is cool!

• ▶ Reply

Permalink Reply by Paul Craig on January 8, 2018 at 8:43am

Yeah I was suggesting the dowel in the bottle spout/neck, but either way will probably work for awhile anyway. Haha

With the dowel in the bottle spout, you'll need a fretboard that's angled to follow the angle of the string. I cut a fretboard out of Pine and glued it to the dowel.It's about 3/16ths" thick at one end and 7/8ths" at the other end.

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page