Black Frets

Replies to This Discussion

Permalink Reply by Wes Yates on February 17, 2010 at 10:09am

:-P

Reboots indeed. Hah. CentOS is King o'Linux.

-WY

Iggy said:

Life is too short for reboots. Long live Ubuntu!!

Wes Yates said:

I are indeed!

-WY

michael harris said:

hey Wes Yates are you a linux fan?

▶ Reply to This

Permalink Reply by Jason Hitesman on February 17, 2010 at 4:34pm

You could try using a patina compound on some fret wire:

http://www.delphiglass.com/index.cfm?page=itemView&itemsysid=12...

Not sure if there's any fret wire with a high enough zinc content for it to work well though....

▶ Reply to This

Permalink Reply by Rick Martin on February 25, 2010 at 9:50am

I've seen some black fishing line out there. If you could find it thick enough, it might do the job...for awhile at least, until the strings wore into the frets.

▶ Reply to This

Permalink Reply by Richard D. DeRoin on March 11, 2010 at 10:48am

Use brass fret material. Then a heavy dose of ooxidizing agent (nitric acid) then a good dose of india ink. I would think that should do it.

▶ Reply to This

Permalink Reply by Bob Harrison on March 11, 2010 at 11:39pm

Fretmonkey,
I have been giving this some thought lately. I was thinking old 78 records would look nice as inlayed fret markers. And to keep the theme going use the same as a face for the peghead and pickguard.

Cheers
Bob

▶ Reply to This

Permalink Reply by FretMonkey on March 12, 2010 at 9:38am

Nice Bob! That does sound very cool!

Bob Harrison said:

Fretmonkey,
I have been giving this some thought lately. I was thinking old 78 records would look nice as inlayed fret markers. And to keep the theme going use the same as a face for the peghead and pickguard.

Cheers
Bob

▶ Reply to This

Permalink Reply by Craig Winkelmann on March 13, 2010 at 7:33am

Dragon Plate sells CF rods, - http://www.dragonplate.com/ecart/categories.asp?cID=39 - though I don't recommend CF (when the epoxy scratches the carbon will become brittle).

You could anneal steel the old fashion way:
Heat steel to red hot and dip into heavy motor oil, or linseed oil.

Two formulas for blackening brass.
Heat:
Dissolve 1 ounce of copper nitrate in 6 ounces of water, dip, then heat the brass.

Non Heat Method:
Sodium Sulfide 1 ounce, Hydrochloric acid 1/2 ounce, 10 ounces of water. Apply with a small brush or a Qtip.

CAUTION: Always wear eye protection and gloves when working with chemicals. Use respirators when cutting carbon fiber, and when working with solvents and metals. Read instructions before mixing acid, or working with chemicals. Never reuse containers for food preparation.

▶ Reply to This

Permalink Reply by Hip Bone Bellaire on March 13, 2010 at 9:47am

Auto Pin Tape for the flat ones... works great..

▶ Reply to This

▶ Reply to This

• ‹ Previous
• 1
• 2
• Next ›
• Page